Rice-lake iQUBE2 Digital Diagnostic Junction Box - Transient Bedienungsanleitung PDF herunterladen

February 2014 160051

iQube

Junction Box

Transient Protection Kit Installation

Transient protection boards are recommended on each end of a power supply run when an external DC supply is

used, and on any power supply cables to secondary units where the secondary enclosure runs are longer than 75

feet. To replace a transient protection board (PN 101369) in the iQUBE

use the following instructions.

Note

For more information on the iQube

, see the Installation manual (PN 106113).

Manuals can be viewed or downloaded from the Rice Lake Weighing Systems website at

www.ricelake.com.

Mounting Bracket

PN 107026

4-40NC x 1/4 screws

PN 14825

Transient Protection Board

109396

Figure 1. Transient Protection Kit

With AC/DC Power Installed

1. Disconnect the power to the iQUBE

2. Loosen the top screws and remove the cover from the iQUBE

3. Disconnect all cables attached to the power board.

4. Loosen screws to remove the power board assembly.

Remove CPU board

power cable

Remove AC Input

cable

Screws connecting power

assembly to enclosure

Figure 2. Remove Power Board Assembly

Note

Transient Protection Kit comes assembled to a mounting bracket, for installation in unit with AC power the

mounting bracket can be removed from the transient boar

d and discarded. Transient protection board can be

mounted to the bottom of existing power supply mounting bracket.

The transient protection board can be installed in either direction

, the connectors are crossed over to prevent a

connection error.

5. Align transient protection board assembly with the standoffs located on the bottom of the mounting bracket

6. Secure to bracket with four 4-40NC x 1/4 screws.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - With AC/DC Power Installed

February 2014 160051iQube2 Junction BoxTransient Protection Kit InstallationTransient protection boards are recommended on each end of a power supply

Seite 2 - Figure 3-1. Connect Cables

Existing Power Supply AssemblyStandoffsTransient Protection Board4-40NC x 1/4 screws2 Transient Protection Kit InstallationFigure 3. Install Transient

Seite 3 - Without AC/DC Power Installed

Transient Protection Kit Installation 3Without AC/DC Power Installed1. Disconnect the power to the iQUBE2.2. Loosen the top screws and remove the cove

Seite 4

230 W. Coleman St. t Rice Lake, WI 54868 t USAU.S. 800-472-6703 t Canada/Mexico 800-321-6703 t International 715-234-9171 t Europe +31 (0) 88 2349171w

Kommentare zu diesen Handbüchern

Keine Kommentare

Rice-lake iQUBE2 Digital Diagnostic Junction Box - Transient Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Waage Rice-lake iQUBE2 Digital Diagnostic Junction Box - Transient herunter. Rice Lake iQUBE2 Digital Diagnostic Junction Box - Transient Protection Kit User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Waage Rice-lake iQUBE2 Digital Diagnostic Junction Box - Transient